VPN/DSL Security Option Configuration
24-10618-155 Rev. A 2-5
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
NetScreen-5XT Router Installation and Configuration
This section describes how to install and configure the NetScreen-5XT router.
Figure 2-4: NetScreen-5XT Back End Installation
NetScreen-5XT Installation
The NetScreen-5XT router may be used as the front end router, back end router, or
both.
T
o install the NetScreen-5XT router:
1. Connect the power adapter to the rear panel
of the NetScreen-5XT.
The NetScreen-5XT device runs a 100-240 V
AC +/- 10% and 12 watts. When
properly connected to an AC power source, the power LED on the faceplate
illuminates solid green. When power fails, the power LED turns off.
2. Connect a network cable from a laptop or PC
to one of the NetScreen-5XT’s
available Trusted ports.
This connection will be used to configure the NetScreen’
s settings.
3. Back End Inst
allation: Connect a network cable from the P2000 Server to a
Trusted port of the NetScreen-5XT router. See Figure 2-4.
Laptop or PC
UNTRUSTED
NetScreen-5XT Back End Router
Ethernet
TRUSTED
43 2 1
DC POWER
CONSOLE MODEM
Used for Configuration
Purposes Only
P2000 Server
(Rear View)
Ethernet
WAN
To Next Page
Loading...
