VPN/DSL Security Option Configuration
24-10618-155 Rev. A 2-15
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
On the VPN tab:
1. Select the Enable radio button next to This Tunnel.
2. Enter a Tunnel Name. This name should be unique for this particular tunnel.
3. Verify that Subnet is the option selected from the Local Secure Group field.
4. Enter 200.0.0.0 as the IP Address.
5. Select Subnet from the Remote Secure Group field.
6. Enter as the IP ADDress Subnet ID in the IP field. This is the IP Address of
the remote endpoint on the other side of the tunnel (for example,
192.168.1.0).
7. Select IP Address from the Remote Security Gateway field and enter
201.0.0.2 as the IP address.
8. Select 3DES for Encryption and SHA for Authentication.
9. Select the PFS (Perfect Forward Secrecy) check box and verify that
master is entered in the Pre-shared Key field.
10. Click the Connect button to establish a connection.
11. Verify that the Status indicates that the Router is Connected.
Linksys BEFSX41 Router Installation and Configuration
This section describes how to install and configure the Linksys BEFSX41 router.
This router may only be used as the front end router.
Linksys BEFSX41 Installation
All connections to the Linksys BEFSX41 router are made to the device’s rear panel.
To install the BEFSX41 router:
1. Connect the power adapter to the rear panel of the Linksys BEFSX41.
2. Connect a network cable from a laptop or PC to one of the Linksys
BEFSX41’s available Ports 1-4. This connection will be used to configure the
router’s settings.
3. Connect a network cable from one of the Linksys BEFSX41’s available Ports
1-4 to the Controller or Workstation.
To Next Page
Loading...
