VPN/DSL Security Option Configuration
24-10618-155 Rev. A 2-17
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2012 Johnson Controls, Inc.
3. Enter admin in the Password field and leave the User Name field blank.
Click OK.
4. On the Linksys Setup window, click the VP
N tab.
On the VPN tab:
1. Select the Enab
le radio button next to This Tunnel.
2. Enter a T
unnel Name. This name should be unique for this particular tunnel.
3. Verify that Subnet is the option selected from the L
ocal Secure Group field.
Verify also that the IP Address is 192.168.1.0
4. Select Subnet from the Re
mote Secure Group field.
5. Enter the IP Addr
ess Subnet ID in the IP field. This would be the IP Address
of the remote endpoint on the other side of the tunnel (for example,
200.0.0.0).
6. Select IP
Address from the Remote Security Gateway field and enter
201.0.0.1 as the IP address.
7. Select 3DES for Encryption and SHA for
Authentication.
8. Select the PFS
(Perfect Forward Secrecy) check box and verify that
master is entered in the Pre-shared Key field.
9. Click the Conn
ect button to establish a connection.
10. Verify that the St
atus indicates that the Router is Connected.
To Next Page
Loading...
