CKM-CE75-E1M Installation and Wiring
24-10707-112 Rev. D
3-7
In addition to these components, you can mount the following CKM devices in
a CKM-CE75-E1M enclosure:
• EP1501
•MR50
•MR51E
Mounting Options
Once the CKM-F8P power distribution module is installed in the CKM-CE75-
E1M enclosure, there is space for up to two CKM devices, labeled A and B in
Figure 3-6.
The EP1501 and the MR51E can be mounted in either location. However, the
MR50 can only be mounted in location B. This is because the integrated screws
necessary for mounting the MR50 are found only in location B.
The integrated screws needed for mounting an EP1501 or MR51E are found in
both locations.
Figure 3-6: Enclosure Component Locations
NOTE: When determining locations for your CKM devices, if you are mounting
an MR50, make sure to mount it in location B only.
To Next Page
Loading...
