VFD68 Variable Frequency Drives (575 VAC)
15
Making High-Voltage Wiring Connections
1. Push down on the hooks at Position A and Position B and pull it away from the VFD68 Drive, using the
hooks at Position C as supporting points (Figure 8).
2. Remove the high-voltage wiring cover at the bottom of the VFD68 Drive by pulling in the direction of Arrow
A (Figure 9).
3. Connect a 575 VAC three-phase power supply to high-voltage terminals R/L1, S/L2, and T/L3 (Figure 10).
4. Connect the high-voltage power supply to terminals R/L1, S/L2, and T/L3 on the drive (Figure 10).
Figure 8: Release the Hooks and Remove the Front Cover
Figure 9: Remove the High-Voltage Wiring Cover
Wiring Hole
To Next Page
Loading...
