T60xDFH-4 and T60xDFH-4+PIR Series Thermostat Controllers with Dehumidification and Occupancy
Sensing Capability Installation Instructions
16
Lockout Selectable Lockout Levels for
limiting end-user keypad interaction.
Default: 0
Lockout
Level
Function
Mode
Setting
Fan
Setting
Local
Override
Occupied
Temperature
Setpoints
(0) Access Access Access Access
(1) Access Access No Access Access
(2) No Access No Access Access Access
(3) No Access No Access No Access Access
(4) No Access No Access Access No Access
(5) No Access No Access No Access No Access
Pipe No Selectable number of pipes in the
system.
Default: 4.0 Pipes
(2.0 Pipes): Limits the number of sequences of operation available
from 0 to 3, and enables heat/cool operation from the same output.
(4.0 Pipes): Allows access to all sequences of operation from 0 to 5,
and enables heat/cool operation from different outputs.
CntrlTyp Defines the control output for the
type of valves used in the
installation (T602 and T603
models).
Default: Floating
(On/Off): For Normally Open (N.O.) or Normally Closed (N.C.)
24 VAC two-position valves.
(Floating): For three-wire control of 24 VAC floating valves.
SeqOpera Determines the sequence of
operation.
Default: 1
Sequence of Operation Default Based on
AutoMode Parameter
Setting
On Off
(0): Cooling Only (Off-Cool) Cool Cool
(1): Heating Only (Off-Heat) Heat Heat
(2): Cooling and Reheat (Off-Auto*-
Heat-Cool)
Auto Heat
(3): Heating and Reheat (Off-Heat) Heat Heat
(4):Cool/Heat Four-Pipe (Off-Auto*-
Heat-Cool)
Auto Heat
(5): Cool/Heat Four-Pipe and Reheat
(Off-Auto*-Heat-Cool)
Auto Heat
* Auto can be disabled with the AutoMode parameter.
Note: Choose the selection option (0): Cooling Only when using a
changeover sensor to allow changeover to occur between Cooling
Only and Heating Only.
Note: Default parameter settings are always equal to off when the
mode is equal to off.
Fan Menu Sets the fan mode options.
Default: 4
(0): Low-Med-High: Three-speed configuration using three fan
relays (L-M-H). The default is High.
(1): Low-High: Two-speed configuration using two fan relays (L-H).
The default is High.
(2): Low-Med-High-Auto: Three-speed configuration with Auto Fan
speed mode using three fan relays (L-M-H). The default is High.
(3): Low-High-Auto: Two-speed configuration with Auto Fan speed
mode using two fan relays (L-H). The default is High.
(4): On-Auto: One-speed configuration, (H) Auto is for Fan on
demand and On is for Fan on all the time. The default is Auto.
Table 4: Installer Configuration Menu (Part 3 of 7)
Parameter
Appearing
on Display
Description and Default Selection Options
To Next Page
Loading...
