Johnson Controls Unisab III User Manual

Settings for Unisab III
(1)
(*S) (*S) (*S)
> Oil > Filter Pressure > Discharge > Superheat
Oil T t
> Oil > Pump Pressure > Discharge > Pressure ratio > Suction > Internal pressure
High
Shutdown
[ºC/R]
Low
Shutdown
> Suction > Superheat
High Alarm Low Alarm
> Discharge > Pressure Deg > Discharge > Temperature > Oil > Pressure
Run TimeSetpoint 1 Setpoint 2 Proportion
al band
Neutral
zone
> Suction > Pressure Deg
Min PulseIntegral
time
[ºC/R]
Control values
Differential
time
(*S) (*S) (*S) (*R) (*R)
The availability of the framed areas depends on the value selected in “Control on”. The availability of the areas in this colour depends on the configuration. The areas in this colour are never available.
(*S) = Screw, (*R) = Reciprocating (1) The value(s) will be changed to factory settings by a “Factory reset”.
> Process Temp > Liquid level > Intermediate > Intermediate Temperature >
Oil
>
T
emperature
> Process Temp > Superheat > Motor > Current > Capacity > VI Slide Position > Capacity > Capacity > Oil > Separator Temp > Motor > Power > User > User input 1 > Intermediate > Intermediate Pressure Deg [ºC/R] > Process Temp > Out temperature > Process Temp > In temperature
3 / 5

Johnson Controls Unisab III Specifications

General

Brand	Johnson Controls
Model	Unisab III
Category	Control Systems
Language	English