To Next PageTo Next Page
Need help?Do you have a question about the Johnson Controls M510CJ and is the answer not in the manual?
General| Brand | Johnson Controls |
|---|---|
| Model | M510CJ |
| Category | Control Systems |
| Language | English |
Details the AIM-200's features, software requirements, and compatibility with the FC-2000 system.
Step-by-step instructions for mounting the AIM-200 module onto the CHS-4 Chassis and connecting it.
Explains various wiring configurations for the AIM-200 communications loop, including circuit types.
Details wiring for the M500XJ loop isolator module, crucial for fault isolation on the loop.
Wiring instructions for the M500MJ monitor module, used for monitoring initiating devices.
Wiring guide for the M501MJ monitor module, a compact version of the M500MJ.
Wiring for the M510CJ control module, supporting appliance circuits and Form-C relays.
Instructions for installing and setting the address for the BGX-101L addressable manual pull station.
Guidance on installing intelligent detectors, including base wiring and setting detector addresses.
Steps for organizing and inserting the AIM-200 module's programming cards into the unit.
Explains the device display, status indicators, and key programming modes like Auto-Program and Program Edit.
Details on mapping devices to zones and selecting zones using the AIM-200's interface switches.
How to adjust detector sensitivity (low, normal, high) and disable detectors via programming.
Programming M510CJ modules for Indicating Appliance Circuit (IAC) or Form-C relay functions.
Guidance on using the Auto-Program mode for device initialization, detection, and configuration.
Calculates the standby current requirements for the AIM-200 module and connected devices.
Calculates the alarm current requirements for the AIM-200 module and connected devices.
