5. Hold the WRG1830 in place, insert the screws through the mounting clips and into the screw
holes, and then carefully tighten all screws.
Important: Do not overtighten the mounting screws. Overtightening the screws can
damage the mounting clips.
Figure 1: Wall mounting and dimensions detail
DIN rail mounting
About this task:
To mount the WRG1830 on a DIN rail, complete the following steps:
Note: Mount the WRG1830 in the horizontal position.
1. Mount a 7.5 cm (3 in.) or longer section of 35 mm (1 to 1/8 in.) DIN rail horizontally.
2. On the back of the WRG1830, extend the bottom two mounting clips.
3. Place the WRG1830 on the DIN rail, so that the DIN rail channel hooks,A, at the bottom of the
baseplate channel catch the lower part of the DIN rail, see Figure 2.
4. Push the bottom mounting clips up to secure the WRG1830 on the DIN rail.
3Wireless Router Gateway Installation Guide
To Next Page
Loading...