Figure 2: Din Rail mounting detail
5. To remove the WRG1830 from the DIN rail, extend the bottom mounting clips to the extended
position and carefully lift the WRG1830 off the DIN rail.
Wiring
Wiring guidelines
Follow these guidelines when you wire the WRG1830:
• Do not hang the WRG1830 from a cable connection.
• Provide slack in the cable between the WRG1830 and the device you connect it to.
Power supply connections
About this task:
CAUTION
Risk of Property Damage.
Do not apply power to the system before checking all wiring connections. Short circuited or improperly
connected wires may result in permanent damage to the equipment.
ATTENTION
Risque de dégâts matériels.
Ne pas mettre le système sous tension avant d'avoir vérifié tous les raccords de câblage. Des fils
formant un court-circuit ou connectés de façon incorrecte risquent d'endommager irrémédiablement
l'équipement.
Wireless Router Gateway Installation Guide4
To Next Page
Loading...