Johnson Controls WRG1830 - WRG LED Status Table

Figure 6: LED map
Table 1: WRG LED designations and operation
LED name Description
HEARTBEAT Off - No 24VAC
On blue - power
FAULT Off - OK
Blinking - starting up
- Factory reset in progress
On - fault detected
ETHERNET Off - Ethernet cable not connected
Blinking - Ethernet active
On - Ethernet cable connected, no activity
ETHERNET
LINK SPEED
Off - 10Mbps
Yellow - 100Mbps
Blue - 1Gbps
Wi-Fi ACTIVITY Off - AP disabled
Blinking - AP enabled, client connected
On - AP enabled, no activity
USB-1 Off - No device detected
Blinking - device detected, no driver
On - device detected
ZFR JOIN
ENABLE
Off - ZFR Join disabled
Yellow - ZFR Join standby (PB enabled)
Red - ZFR Join enabled
Note: This mimics the LED on the ZFR
USB-2 Off - No device detected
Blinking - device detected, no driver
On - device detected
ZFR ACTIVITY Off - ZFR [Serial] Comms inactive
Blinking - ZFR [Serial/Wireless] Comms active
On - ZFR [Serial] Comms lost
9Wireless Router Gateway Installation Guide