EasyManua.ls Logo

Johnson Controls YICM012B21S - Power Supply On;Off 1 (Automatic Operation When Power Supply Is On); Power Supply On;Off 2 (Restarting Function After Power Failure)

Johnson Controls YICM012B21S
152 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SM-18003
5-11
EXTERNAL INPUT/OUTPUT AND FUNCTION SETTING
5.4.1.2 PowerSupplyON/OFF1(AutomaticOperationWhenPowerSupplyIsON)
Thisfunctionisutilizedtorun/stoptheunitbyturningON/OFFthepowersupply.Whenthisfunction
isutilizedintheconditionthatthereisnopersontooperatetheunit,monitorthesystemfordisaster
prevention.Whenusingthisfunction,refertoSection5.4.2.2"(30)PowerSupplyON/OFF(Automatic
Operation WhenPowerSupplyIsON)(d1)"forthesetting.
NOTE:
1.TheunitwillbestoppedevenwhenthepowersupplyisturnedON/OFFduetopowerfailure.Ifpower
failureoccursduringthestoppageoftheunit,theoperationisrestartedafterthepowersupplyis
restored.
2.WiredControllerisrequiredforthisfunction.
3.Whenthecommunicationcableisnotusedinthetwin,tripleandquadcombinationsforsimultaneous
operation,setthisfunctiononlytothemainindoorunit.
5.4.1.3 PowerSupplyON/OFF2(RestartingFunctionAfterPowerFailure)
Thisfunctionisutilizedtorestarttheunitoperationautomaticallywhenthepowersupplyisrestoredafter
thepowerfailureover2seconds.Incaseofthepowerfailurefor2secondsorless,thestandardunit
memorizealltheoperationmodeandrestartstheoperationautomatically.(Thecompressorrestarts
operationafter3minutesguardinadditiontopowerfailuretimeforupto2seconds.)
Whenthisfunctionisutilizedintheconditionthatthereisnopersontooperatetheunit,monitorthesystem
fordisasterprevention.Whenusingthisfunction,refertoSection5.4.2.2"(32)PowerSupplyON/OFF
(RestartingFunctionafterPowerFailure)(d3)"forsetting.
NOTE:
1.Ifpowerfailureoccursduringthestoppageoftheunit,theunitremainsstoppedafterthepowersupplyis
restored.
2.WiredControllerisrequiredtobeconnectedforsettingthisfunction.
3.Whenthecommunicationcableisnotusedinthetwin,tripleandquadcombinationsforsimultaneous
operation,setthisfunctiononlytothemainindoorunit.

Table of Contents

Related product manuals