4-9
Console Diagnostics Mode
SETP 5
STEP 6
STEP 7
STEP 8
1. Press the ENTER key.
2. In the Dot Matrix Display there will be two hearts
on it, which will light up completely in turn
3. “STEPS/MINS” windows will show the current
heart rate while you are wearing a HAND PULSE
SENSOR or POLAR CHEST BELT.
If the heart rate is not shown or not stable in the
display, please refer to section 4-8 ~ section 4-10
1. Press the ENTER key.
2. Dot Matrix Display will show “D/A”.
3. Press “+/-“ key to increase or decrease resistance.
If there is no resistance, please refer to section 4-4~
section 4-5.
1. Press the ENTER key.
2. Dot Matrix Display will show “KEY” on it.
3. Ready for you to enter any key of all 18 keys other
than “RESET” now to verify the function of the
key..
4. The RPM window will show you a reference
number accordingly while pressing a number or
function key.
5. “TIME” window will show you the programming
year of the software.
6. “WORK LEVEL” windows will show you the
programming month and day.
7. “PULSE “ window will show you the software
version.
If any of the keys does not work, please refer to
section 4-3
1. Press the ENTER key. This completes the
procedure.
To Next Page
Loading...
Need help?
General
