USE
USE
1312
4 Place buckle tongues into
the quick release buckle.
IMPORTANT: Both buckle
tongues should "CLICK"
into place.
If they do not click, try
again or try cleaning the
buckle. See page
21.
5 Tighten harness by
pulling on the adjuster
strap at the front of the
restraint (B).
Note: you may need to
pull excess shoulder strap
webbing through the Quick
Release Buckle Tongues
upward towards the child’s
shoulder (A) and then pull on
the adjuster strap (B).
This may need to be
repeated several times to get
the webbing tting snugly.
"CLICK"
WARNING
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR
4
5
A
B
A
Securing Child in the Restraint
1
3
1 Loosen harness by
pressing on adjuster but-
ton while pulling on the
harness straps.
2 Press button to open the
quick release buckle (A).
Spread harness straps
apart (B).
3 Place child in restraint in
seated position.
Child's back must be
rmly against both the
back and bottom of the
restraint.
First check shoulder strap
height and adjust if neces-
sary.
See pages 8 & 9.
2
A
B