32
INSTALLATION
INSTALLATION
Vehicle Belt
must always be secure
and pulled tight.
See pages 10 & 11
Carry Handle
must always be locked
into position.
Tether Strap
must always be used when the
restraint is installed in a vehicle.
Store end of tether in bag.
See pages 14 - 16
Base Recline Adjustment
base must be reclined correctly
See pages 7 & 8
Secure Latching
restraint must be
securely latched
into base.
See page 12
Quick Reference
• Use the restraint exactly as shown in the instructions.
• Fit the restraint firmly to the car seat.
• A loose harness or restraint is dangerous.
• Destroy the restraint if it has been in a severe crash,
even if no damage is visible.
• Do not alter or modify this restraint.
• Repairs must only be done by the manufacturer or
agent.
• This child restraint is not approved for use with any
connectors that connect to the car’s ISOFIX low
anchorages.
• DO NOT USE A REAR FACING CHILD RESTRAINT
WHERE AN AIRBAG IS FITTED IN FRONT OF THE
SEATING POSITION.
• Only use this restraint with the base it was supplied
with. If a second or replacement base is required it
must be a matching model number.
WARNINGS
NOTE: The warnings on these pages are those
required by the Australian and New Zealand
Standard AS/NZS 1754 for this type of child
restraint. Other warnings specific to this
particular child restraint will be found throughout
these instructions.
IMPORTANT: Also read the following instructions carefully
Read the whole of these instructions carefully and if there
is any doubt about the method of installation, consult the
child restraint manufacturer or agent, or a child restraint
tting station authorized by the relevant transport
authority, or in New Zealand an agent for the vehicle.
To Next Page
Loading...
Need help?
General
