1312
INSTALLATION
INSTALLATION
To Install
First make sure there is
nothing in or on the base
(blankets, toys etc).
These may stop the
restraint from latching
securely.
Lower the restraint down
into the base. Listen for a
"CLICK" from the latches in
the base.
Pull up on the restraint
to ensure it is securely
latched.
To Release
Lift the restraint with one
hand while pulling up on
the release latch at the
back of the base.
"CLICK"
WARNINGS
TETHER STRAP
THIS RESTRAINT MUST BE ATTACHED TO A CHILD
RESTRAINT UPPER ANCHORAGE POINT IN THE CAR.
REFER TO CAR OWNERS HANDBOOK FOR LOCATION
OF ANCHORAGE POINTS.
REFER TO A CHILD RESTRAINT FITTING STATION IF NO
ANCHORAGE POINTS ARE IN THE MOTOR CAR.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE
THE TOP TETHER STRAP MAY FALL INTO A SPLIT IN
THE SEAT BACK OR OFF THE SIDE OF THE SEAT.
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by
the child. It should be stored in the bag provided on the
end of the strap.
Do not use the child restraint where this strap may fall into
a split in the seat back or off the side of the seat.
ALWAYS ATTACH HOOK AND REMOVE SLACK.
CAUTION: CHILDREN CAN BE INJURED OR RE-
STRAINTS AND TOP TETHER STRAP DAMAGED BY
UNSECURED CARGO IN A COLLISION.
SECURE OR REMOVE HAZARDOUS CARGO BEFORE
USING THIS CHILD RESTRAINT.
Fitting Restraint to Base
To Next Page
Loading...
Need help?
General
