To Next Page
C
clarkbrentAug 1, 2025
What to do if the Jolimark Printer cutter is jammed?
- WWesley PerryAug 1, 2025
If the cutter is jammed on your Jolimark Printer, open the upper cover and take out the paper.
What to do if the Jolimark Printer cutter is jammed?
If the cutter is jammed on your Jolimark Printer, open the upper cover and take out the paper.
What to do if my Jolimark Printer cover is open?
If the cover of your Jolimark Printer is open, close it tightly.
What to do if the Jolimark TP820 is out of paper?
If your Jolimark Printer is out of paper, load the paper again.
What to do if my Jolimark Printer says paper near end?
If your Jolimark Printer indicates that the paper is near the end, load the paper again.
How to fix thermal head over hot on Jolimark Printer?
If the thermal head of your Jolimark Printer is too hot, it will recover automatically.
High-speed mini thermal printer for POS applications.
Details TP820 models based on interface and cutter type.
Diagram identifying key physical components of the printer.
Instructions for unpacking the printer and its accessories.
Steps for connecting various interface cables (Parallel, Serial, USB, etc.).
Procedure for connecting the printer's power adapter and cord.
Guide to installing the printer driver and configuring cutter settings.
Steps to connect the printer to a Local Area Network (LAN).
Instructions for configuring the printer's IP address using NetFinder.
Details of indicators (POWER, ERROR, PAPER OUT) and the FEED key.
Procedure for performing a self-test to verify printer functionality.
Checks printer-host connection status using HEX DUMP mode.
How to reset the printer to its original factory default settings.
Information on the slip stitch for firmware upgrades and normal operation.
Adjusting printer parameters via PC software and driver properties.
Step-by-step guide for installing and replacing the paper roll.
Detailed technical specifications including print method, speed, resolution, and dimensions.
Details the parallel interface compatibility and pin assignments.
Details the serial interface compatibility and pin assignments.
Information on the full-speed USB 2.0 interface.
Details of the RJ-11 drawer connector and its pin assignments.
Specifications for the power connector and required voltage/current.
Identifies the Ethernet connector.
Guidelines for cleaning and maintaining the printer for longevity.
Explains error indicators, malfunctions, and their solutions.
Steps to resolve issues with a jammed or malfunctioning auto-cutter.
Introduction to the ESC/POS based command set and compatibility.
Explanation of fundamental commands like BEL, HT, LF, and FF.
General| Type | Dot Matrix Printer |
|---|---|
| Print Speed | 300 characters per second |
| Connectivity | Parallel |
| Print Speed (Dot Matrix) | 300 characters per second |
| Print Method | Impact dot matrix |
