Jolimark TP820 - Page 39

TP820 User’s Manual
- 36 -
ESC \ Set relative print position
Format: ASCII: ESC \ nL nH
Decimal: 27 92 nL nH
Hex: 1B 5C nL nH
Description:
Set the print position at (nL+nH*256)* (horizontal or vertical motion unit) inches from current
position;
nL,nH=0～255. Horizontal or vertical motion unit is specified by GS P command.
ESC a n Select justification
Format: ASCII: ESC a n
Decimal: 27 97 n
Hex: 1B 61 n
Description:
n=0, 48: Left justification; n=1, 49: centering; n=2, 50; right justification.
ESC c 3 Select paper end sensor
Format: ASCII: ESC c 3 n
Decimal: 27 99 51 n
Hex: 1B 63 33 n
Description:
n=xxxxxxx1B, xxxxxx1xB, xxxxxx11B, Paper near end sensor takes effect.
n=xxxxx1xxB, xxxx1xxxB, xxxx11xxB, Paper end sensor takes effect.
ESC c 4 Select paper sensor to stop printing
Format: ASCII: ESC c 4 n
Decimal: 27 99 52 n
Hex: 1B 63 34 n
Description:
n=xxxxxxx1B, xxxxxx1xB, xxxxxx11B；Paper near end, printer stop printing.
n=xxxxx1xxB, xxxx1xxxB, xxxx11xxB；Paper end, printer stops printing.
ESC c 5 Enable/disable panel button
Format: ASCII: ESC c 5 n
Decimal: 27 99 53 n
Hex: 1B 63 35 n
Description:
When the LSB of n is 0, enable button.
When the LSB of n is 1, disable button.
ESC d Print and feed n lines
Format: ASCII: ESC c n
Decimal: 27 100 n
Hex: 1B 64 n
Description:
Print the data in print buffer and feed n lines, n= 0~255.