Frame centre line measurement
NOTE
Measure Frame Reference for chassis centre line is to be performed according to
customer requirements.
Mount measuring head on to the inner groove of the axle on the centre line tool.
In the Start window click on either [New Order]
if starting a new order.
See chapter "New order" on page 33.
or click on:
[Continue this Order]
to proceed with the current order.
The application window for I-track ll will be displayed.
Click on [I-track ll]
The software will proceed to the main measurement window.
NOTE
Shiny or reective surfaces may disturb the laser equipment. Make sure that any
such surfaces are covered before start of measurement.
i-track II
Measure frame reference
77
To Next Page