Measure a semi-trailer
Mount a wheel adapter on each wheel of the vehicle. Make sure that each wheel adapter is levelled.
Select scale setup for the coming measurement.
Checkbox "Scales are reversed":
Used if the vehicle is reversed into the work bay so that the front of the vehicle is facing the rear
targets. All axles are measured simultaneously.
Checkbox "Scales are mounted on vehicle":
Hang reference targets on the vehicle. Make sure to cover existing scales in the workshop bay.
All axles are measured individually.
No boxes checked:
The software will assume that the scales are assembled in the workshop and that the vehicle is
positioned with the front facing the front scales. All axles are measured simultaneously.
Press [Save & Start Measure]
homebase 4
Measure a semi-trailer
89
To Next Page
Loading...