Measuring for the rst time
Place both measuring heads on the trailer bar, then press OK to start levelling the trailer bar. Adjust
the trailer bar in level, indicated with green digits, using the instructions on the display. When ready,
move the trailer bar sideways so that the laser points exactly in the centre of the king-pin or tow eyelet.
Then press OK or push the button on one of the measuring heads.
Continue the ow by placing measuring head on a wheel adapter on the rst axle and press the button
on the measuring head to take the initial measurements of toe, camber and position of that wheel.
When the software has registered the data the user moves the measuring head to the next axle, which
can be measured the same way.
Up to two operators may measure at the same time using two measuring heads, one on each side.
There is no specied measuring ow other than that all wheels must be measured according to the
software instructions.
i-track II
Measure a trailer
87
To Next Page