Press [Measure] to enter the measurement sequence.
If using the "No boxes checked" or the "Scales are reversed" options you will be required to level
the trailer bar. If using "Scales are mounted on the vehicle" the software will proceed directly to the
measurement sequence.
Mount a wheel adapter on each wheel and make sure that all wheel adapters are levelled.
Levelling the trailer bar
Place the trailer bar on two stands either directly under the king-pin, or directly under the tow eyelet
on the (semi-) trailer. Level the trailer bar using the bubble (ne tuning is done using the measuring
system later during the process). Switch the laser on and point it at the centre of the king-pin or the
tow eyelet.
NOTE
Lock the dolly on a full trailer using the dolly lock by placing it between the dolly
and trailer chassis. Tighten so that the dolly cannot move in relation to the chassis.
i-track II
Measure a trailer
86
To Next Page
Loading...