Continue the ow by placing measuring head on a wheel adapter on the rst axle and press the button
on the measuring head to take the initial measurements of toe, camber and position of that wheel.
When the software has registered the data the operator moves the measuring head to the next axle,
which can be measured the same way. There is no specied measuring ow other than that all wheels
must be measured as instructed by the software.
When the wheels have been measured the operator is instructed to rotate the wheels 180°.
ATTENTION!
Do not use the measuring equipment to rotate the wheel!
homebase 4
Measure a semi-trailer
91
To Next Page