27
The working channel will then be displayed
with large figures in the left part of the
display, channel 16 and the third watch
channel in the right part of the display.
TW will then be indicated in the lower right corner of the display.
The working channel can be changed at any time by pressing the «CH» (4) key
and using the arrow keys (2&9) to select channel and then «Enter» (11)
to confirm (ref 4.2).
Switching DW/TW on and off.
When double or triple watch is selected, DW or TW is turned on and off by pressing
the «Enter» (11) key. When activated, «DW» or «TW› is indicated in the display.
When the Tron TR20 is in DW or TW and receives a signal, the channel number
being received will be displayed on the left side of the display. If the «Enter» (11)
key is pressed while receiving a signal, the Tron TR20 will switch to single watch
and be able to transmit at the same channel.
To return to the original DW/TW setup, press «Enter»(11) again.
Note!
The radio is not able to transmit when it is set to double or triple watch.
To transmit, DW/TW has to be turned off by pressing the «Enter»(11) key.
However, if channel 16 is selected it is always possible to transmit, regardless
of the DW/TW setting.
To Next Page
Loading...
Need help?
General
