28
Install the dirty water tank
Put dry filter and filter net into the top cover of the dirty water tank, and then install the top cover on the dirty water
tank. Finally, tightly install the dirty water tank back to the main body.
Clean the rolling brush
Remove the rolling brush as described in the "Dismantle and install the rolling
brush" on Page 9, clean away the hair or debris on the brush head with the
cleaning tool provided together with the product, and then clean the brush
with water. After cleaning is completed, install the rolling brush as described
in the "Dismantle and install the rolling brush" on Page 11.
Tip: After cleaning is completed, it is recommended to dry the rolling brush
before using it again. It is recommended to replace the rolling brush every
six months.
Clean the charging base
Remove the power adapter before maintenance. Wipe the charging base with
wet cloth, but not wipe the adapter near the charging port with wet cloth. Use
the charging base only after it dries.
Storage
Clean the clean water tank, dirty water tank and
rolling brush, dry them, and then store them
separately. Fully charge the battery, remove the
battery and place it separately. To avoid damage
to the battery, fully charge the battery at least
every three months. Store the battery at a dry and
ventilated place where there is no direct sunlight.
C
M
Y
CM
MY
CY
CMY
K
To Next Page
Loading...