General Section 16
SYSTEM MODE –
Functions Common to ACRO, GLIDER and HELI model types
System mode contains the foundational programming.
System mode screens include model name, model
reset, modulation, data transfer, etc.—functions that are
typically set once and then are seldom changed or
adjusted. This section describes the system functions
that are common to all 3 model types. System functions
that are specific to each model type are covered in the
each of the acro, glider and heli sections.
To enter System Mode–
Press ENT and hold while turning on the transmitter. The screen should appear as follows.
Note: In HELI mode the Wing Type function is replaced by the Swash Type function.
System mode contains the follow screens:
Info Display
Model Select / Copy Pg 17
Model Name Pg 17
Type Select Pg. 18
Model Reset Pg. 19
Modulation Pg. 19
Transfer Pg 20
Trainer Pg 22
Stick Mode Pg 22
Stick Direction Pg 22
To Next Page
Loading...
