General Section 20
Transfer – Transfer the model to another transmitter or to DataSafe
The TRANSFER function can be found in the SYSTEM
Menu and is used to copy the contents of a model
memory to another PCM9X II transmitter or to a
DataSafe device on a Personal Computer (PC). It is
also used to receive data for a model, either from
another PCM9X II transmitter or from a DataSafe unit.
Transfer a model from the PCM9X II – (Transfer function)
1. Hold the ENT button while plugging the trainer cord
into the back of the transmitter to obtain the SYSTEM
Menu.
Plug the other end of the trainer cord into another
PCM9X II transmitter while holding the ENT button
down and prepare that transmitter for Receive as
described below. Or, plug the other end of the trainer
cord into a DataSafe unit and prepare the DataSafe to
receive.
2. Highlight and select TRANSFER in the SYSTEM
Menu to obtain the Transfer display.
3. The model to be transferred must be the currently
selected model. If the model to be transferred is not
currently selected, see Model SEL in the SYSTEM
Menu to select the model to be transferred to
another PCM9X II or DataSafe unit.
4. When the receiving device is ready, press the CLR
button next to START on the left side of the display.
The data for the currently selected model is
transferred to the receiving device.
To Next Page
Loading...
