General Section 26
PCM9X II used as Slave (Student) – (Trainer System)
1. If the PCM9X II is to be used as the Slave TX (TX
used by the student), be sure that the currently
selected model is set to PPM Modulation (see
MODULAT in the SYSTEM Menu if the Slave TX is a
PCM9X II).
2. Highlight and select MASTER and the display will
switch to SLAVE. A message will appear instructing
to Connect DSC & POWER off. Make sure the TX
power switch is in the Off position and the DSC cord
is connected between the 2 transmitters.
The PCM9X II is now ready to be used as the Slave or
student TX.
To Next Page
Loading...
Need help?
General
