JRC JCY-1900 - Software Update

2. MAINTENANCE
JCY-1900
/
1950
V
DR Service Manual
47
DOC No. 7ZPNA4409
2.9. Software Update
2.9.1. Software Update
The MCB, ARB and OPU software can be updated. Refer to Installation Manual (Software Part) section 9 for more in-
formation.
1) Log in to the maintenance software, and select [Software Update] ⇒ Tab[SOFTWARE UPDATE].
2) Select Tab[RCU] or [OPU].
3) Click [Browse], and select program file for update.
4) Click [Update], and then update is started.
2.9.2. Setting of expiration date in Replacement Parts
Set the expiration date (month / year) of replacement parts. Refer to Installation Manual (Software Part) 4.3.2 for more
information.
1) Log in to the maintenance software, and select [Home]⇒Tab[Installation]⇒[SYSTEM].
2) Select Tab[Replacement parts].
3) Input the expiration date, and click [Set].
4) Operation time (unit: time) of some parts is calculated and displayed by the VDR. After Replacement, click [Clear]
to clear the value.
(When Expiration passed 1 year, ● (red) is displayed.)
* Check the setup from the OPU after setup. （Refer to 3.4.3.）