7 – 51
7.5
7.5.6.6 Card 2 to Internal Setting
This function is used to set the contents written in the card to the internal memory. Use this function after
inserting the card to the lower side of the card slot.
Procedures
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
MENU.
2. Press the
7
key to select "CARD 2 to INTERNAL SETTING".
3. Press the
7
key to set the system in the standby mode.
4. Press the
ENT
key to set or the
CLR
key not to set according to the
direction on the screen.
After setting, the screen which appears after turning the power on is displayed.
Exit
5. Press the
SUB
MENU
key.
7.5.6.7 User Memory
This function is used to write the contents currently displayed into the internal memory. The written contents
are not cleared by master resetting.
Procedures
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
MENU.
2. Press the
8
key to select "MEMOLIZE USER SETTING".
3. Press the
8
key to set the system in the user memory standby mode.
4. Press the
ENT
key to write or the
CLR
key not to write according to
the direction on the screen.
After writing, a message informing the completion of writing appears.
Exit
5. Press the
SUB
MENU
key.
To Next Page
Loading...
