JRC JMA-3910-6 - Rejecting Radar Interference; Adjusting Control Panel Brilliance [PANEL DIM]

3 – 13
3.2
3.2.9 Rejecting Radar Interference
● If you'll watch the RADAR BECON and the SAFT, set the process as follows.
IR OFF
Procedures
1. Press the
MAIN
MENU
key to open the MAIN MENU.
2. Press the
6
key to select "IR".
3. Press the
6
key to select "OFF", "IR1", "IR2" or "IR3" according to
the radar interference status.
"IR1", "IR2" or "IR3" then appears on the upper right of the screen to display the
interference rejection circuit operation. "IR3" is most effective for the radar interference.
4. Press the
ENT
key.
Exit
5. Press the
MAIN
MENU
key.
Main menu
MAIN MENU
Press an item number key.
1. RADAR ／ TRACK BRILL
● [DAY1]
2. RR ／ VRM ／ EBL BRILL
● [DAY1]
3. ARPA BRILL
● [DAY1]
4. GRAPHIC DATA BRILL
● [DAY1]
5. PROCESS
OFF PROC1 PROC2 PROC3
6. IR OFF
IR1 IR2 IR3
7. FLOATING EBL
OFF ON
8. VECTOR
TRUE RELATIVE
9.
To close this menu, Press (MAIN MENU) key.
3.2.10 Adjusting Control Panel Brilliance [PANEL DIM]
Procedures
Brilliance increases in the four levels every time the
PANEL
DIM
key is pressed
and pressing it again returns the system to the original status.
Attention