ġ
4-30
4
[III] Geodetic system setting (Geodetic)
Procedures 1. Press [RADAR MENU] key.
The Main Menu will appear.
2. Press [7] key.
The NAV Equipment Setting screen will appear.
3. Press [7] key.
The GPS Setting screen will appear.
4. Press [1] key.
The GPS Process Setting screen will appear.
5. Press [3] key.
The Ten-Key Pad screen will appear.
Enter the geodetic system according to the table on the following page.
The [MULTI] control can be used to enter the value.
6. After the entry has been completed, press [9] key to send the settings to
the GPS receiver.
To Next Page
Loading...
