JRC JMA-5220-7 - Page 315

8─14
8
8.1 Performance Check
yyyy
yyyy
Table 8-2 List of System Error Message (1)
TRX(SSW OFF) Scanner: Safety switch OFF
TRX(AZI) Scanner: BP error
TRX(HL) Scanner: HL error
TRX(MHV) Scanner: Modulator’s high voltage alarm
TRX Scanner: No communication
TRX(DATA) Scanner: Communication software version mismatched, checksum error, or collision
TRX(HEATER) Scanner: Magnetron heater voltage alarm
TRX(REVERSE) Scanner: Reverse rotation
TRX(VIDEO) Scanner: VIDEO error
TRX(TRIGGER) Scanner: TRIGGER error
TRX(FAN 1) Scanner: FAN 1 alarm
TRX(FAN 2) Scanner: FAN 2 alarm
TRX(STAB0) Stabilizer error
TRX(STAB1) Stabilizer error
TRX(STAB2) Stabilizer error
TRX(STAB3) Stabilizer error
TRX(STAB4) Stabilizer error
TRX(STAB5) Stabilizer error
TRX(STAB6) Stabilizer error
TRX(STAB7) Stabilizer error
TRX(STAB8) Stabilizer error
TRX(STAB9) Stabilizer error
TRX(STAB10) Stabilizer error
TRX(STAB11) Stabilizer error
TRX(STAB12) Stabilizer error
TRX(STAB13) Stabilizer error
TRX(STAB14) Stabilizer error
TRX(STAB15) Stabilizer error
TRX(HEATER SUB) Scanner: Magnetron heater voltage alarm (non-selected side of 2 frequencies)
TRX(MHV SUB) Scanner: Modulator’s high voltage alarm (non-selected side of 2 frequencies)
TRX(MOTOR) Scanner: Motor current alarm
PANEL Operation PANEL: Communication error
PANEL(DATA) Operation PANEL: Checksum error
PANEL2 Operation PANEL2: Communication error
PANEL2(DATA) Operation PANEL2: Checksum error
NSK NSK: No communication
NSK(GYRO) NSK: GYRO error (error bit detected)
LOG NSK: Logging error (error bit detected)
ISW ISW: No communication
ISW(DATA) ISW: Data inconsistency, or checksum error