8ļ¼36
JMA-7100 Instruction Manual > 8.COUNTERMEASURE FOR TROUBLE ... > 8.4 REPLACEMENT OF MAJOR PARTS
(You will need to cut the cable band.)
[Assembly]
1) Assemble the module in the reverse order of
disassembly.
2) Check that the module is placed in the
proper position and a proper space is
maintained under the module. Also check the
pull-out position for the brightness
adjustment cables. Tighten the ten M4
screws evenly.
3) Attach the LCD operation circuit cable.
Check the gasket position. Make sure the
brightness adjustment cables are not pinched before attaching the face cover.
4) Tighten the screws at the four corners.
[Operation Check]
1) After completing the replacement procedures, start the system to make sure that images
are displayed properly.
2) Turn the brightness knob to make sure the brightness can be changed between the
minimum and the maximum levels.
Cut the
cable band .
Cable pull-
out position
To Next Page
Loading...
Need help?
General
