2 BASIC OPERATION
2.1 Power ON and Start the System
Procedures
1 Check that the ship’s mains are turned on.
2 Press the [POWER] key.
The system is turned on, and the preheating time is displayed.
Preheat is indicated upper left of the display.
3 Wait until the preheating time is over.
When the preheating time is over, the preheating time screen disappears, and Preheat upper left of
the display changes to Standby .
4 Press the [TX / STBY] key.
The radar will start transmission and the antenna will start rotating.
Standby upper left of the display changes to Transmit .
2
To Next Page
Loading...
Need help?
General
