JRC JMR-7230-S3 - Page 21

5-5 Section 5 Basic Operation of the Radar
1
2
3
4
5
5
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
When the magnetron radar antenna is connected, “Preheat” is displayed on the Standby/Send
switching button.
4 Wait until preheating is complete.
When the preheating time expires, the preheating time display disappears, and the display of
the Standby/Transmit switch button changes from "Preheat" to "Standby".
5 Click on the Standby/Transmit switch button.
Radar transmission starts and the radar antenna rotates.
The display of the Standby/Transmit switch button changes from "Standby" to "Transmit".
Note
Even if the Standby/Transmit switch button is clicked on while "Preheat" is being displayed, radar
transmission cannot be performed.
Memo
When the “Preheat” display is held down (5
seconds or longer), the display is switched to
“Standby”.