JRC JMR-7230-S3 - Switching between Ground Vector and Water Vector; Association Target Symbols

6-11 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.3.7 Switching between Ground Vector and Water
Vector
The vector of an AIS target is to be displayed with a vector over ground or over water by switching the
stabilization mode. The type of the currently displayed vector can be confirmed by viewing the setting
of the stable mode.
When [GND] is selected for the stabilization mode: Ground vector
When [Sea] is displayed for the stabilization mode: Water vector
When the vector of an AIS target is displayed with a vector over water, the system has converted the
AIS target's vector over ground to the vector over water according to the data received from the AIS
and the own ship's information.
6.3.8 Association Target Symbols
When the TT target and AIS target are determined to be the same targets, the association symbols are
displayed as follows.
Symbol display for high-priority TT targets Symbol display for high-priority AIS targets
When the TT target and AIS target are determined to be the same targets, the TT target or AIS target
that are displayed on a higher priority basis can be set.
1 Right-click on the tracked target with association displayed.
The context menu appears.
2 Click on [Property] in the context menu.
The "TT Target INFO" or "AIS Target INFO" dialog appears.
3 Select [AIS] or [TT] from the [Priority] combo box.
[AIS]: The AIS target is displayed on a higher priority basis.
[TT]: The TT target is displayed on a higher priority basis.
Association targets
Association targets