JRC JMR-7230-S3 - Page 90

Section 6 Target Tracking and AIS 6-36
List of target tracking simulator/scenario
Scenario Target No.
Motion
(true motion)
Moving start point
Speed [kn]
Course [
o
]
Range [NM]
Bearing [
o
]
Scenario1
1
28.3
45
9.5
270
2
22.4
27
1.12
333
3
15.3
293
9.25
45
Scenario2
1
30
135
8
23
2
20
270
5
135
Scenario3
1
45
180
5
23
2
0
-
3
340
3
30
0
8
180
Scenario4
1
0
0
2.02
31
2
70
225
7.01
37
Scenario5
1
20
45
4.47
288
2
30
45
5.1
304
3
40
45
6.71
288
4
0
-
7.07
307
5
60
200
12
352
6
20
225
11
315
7
40
190
14.4
349
8
-
-
8
318
9
-
-
9
318
10
-
-
10
318
Scenario6
1
5
96
5
0
2
105
225
6
45
Note
• When the simulator is operating, set 0° as the heading bearing
5 Click on the Standby/Transmit selector button to place the radar in the transmission
state.
The button indication changes to [Transmit].
The simulator turns on, the pseudo-target is generated, and the letter "X" appears on the lower
side of the radar screen and near the pseudo-target to indicate that simulation mode is being
executed.
To cancel simulation
1 Click on the Standby/Transmit selector button to place the radar in the standby state.
The button indication changes to [Standby] to enter transmission preparation state.
2 Select [Off] from the [TT Simulator] combo box in the "TT Test" dialog.
TT Simulator display turns off.