6-2
6.1 Affixing Display Unit Nameplate Labels
Peel the label of the equipment to be used from the accessory product nameplate, and affix it to
the center of the front panel.
When you use the old GPS sensor (except JLR-4341 / 4340 ）, use the seal of "NWZ-4610 GPS."
Peel the label of the equipment to be used from the accessory model identification plate, and affix
it over the upper left blank part of the unit nameplate at the center of the rear case.
When you use the old GPS sensor (except JLR-4341 / 4340 ） , use the seal of "GPS
NAVIGATOR."
After affixing model identification plate
MID Doppler Log GPS Navigator
(Example JLR-7600)
MED mark of Doppler Log is affixed on the signal distributor.
Product Nameplate (Accessory)
Model Identification
Plate (Accessory)
Display Unit Front
Display Unit Rear
To Next Page
Loading...
