5-5. Die Part Replacement
The crimping dies are consumable parts. When a die part
becomes worn and requires replacement, check the part
number engraved on the die part, or consult the ‘exploded
view’ drawing supplied with every applicator and order a
new part from JST technical Services Department.
If you consider that the replacement process is too difficult,
or the tooling has sustained damage, please contact JST
to either send back the tooling for repair or alternatively a
JST Service Engineer can visit your company to repair the
tool on site.
5-6. Lubrication of Applicator
Periodically lubricate the surfaces indicated on the
photographs with grease. A general purpose grease
obtainable from Garages or car accessory shops is suitable.
Remove the ram from the applicator body and apply the
grease to the cam surface.
Apply grease to the surface of the cam-roller.
Apply grease to the four faces of the applicator ram.
CAUTION
Apply grease sparingly because excess grease attracts
dirt and scrap insulation etc.
To Next Page
Loading...
