JST AP-K2 - Default Chapter; Table of Contents

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
3
CONTENTS
1.
Specifications
Page 4
1-1. Crimping machine specifications
Page 4
1-2. Applicator Specifications
Page 4
2.
Installing the machine
Page 5
2-1. Machine Installation
Page 5
3.
Machine preparation
Page 6
3-1. Mounting of the Reel hanger
Page 6
3-2. Mounting of the Applicator
Page 6
Prevention of tooling damage
Page 7
Prevention of terminal damage
Page 8
3-3. Mounting the Terminal reel
Page 9
3-4. Setting the counter
Page 10
3-5. Mounting the Safety guard
Page 10
4.
Operation
Page 11
4-1. Manual operation
Page 11
4-2. Inspection before operation
Page 12
4-3. Operation under power
Page 12
5.
Applicator
Page 13
5-1. Terminal feed position adjustment
Page 13
5-2. Bell mouth adjustment
Page 14
5-3. Feed-finger travel adjustment
Page 15
5-4. Crimp height adjustment
Page 15
5-5. Die part replacement
Page 16
5-6. Lubrication of Applicator
Page 16
6.
Maintenance
Page 17
6-1. Lubrication
Page 17
6-2. Inspection and repair
Page 19
6-3. Positioning the solenoid bracket
Page 20
7.
Fault finding
Page 21
Electrical circuit diagram
Page 25
8.
Exploded views and parts list
AP-K2 Crimping machine exploded view
Page 26
MK-L Applicator
Page 28
MKS-L Applicator
Page 30
MKF-L Applicator
Page 32
MKS-LS Applicator
Page 34