JST AP-K2 - Prevention of Tooling Damage

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
7
PREVENTION OF TOOLING DAMAGE.
1.
Place the rubber collar under the
ram head as shown in picture 1.
IMPORTANT.
Repeat this procedure every time
you remove an applicator from
the press.
Picture 1.
2.
DO NOT leave the applicator
without the rubber collar attached,
as shown in picture 2.
Picture 3.
Picture 2
.
3.
Picture 3, is a zoomed in view of
the punch and anvil when the
rubber collar is left off.
The two circled points are the
points of contact where the
damage will be caused.
Picture 3.