adapter can cause overheating and deformation of the plug.
Contact a qualified electrician to replace the loose or worn
mains socket.
● To disconnect the USB adapter, grasp the adapter housing and
pull the adapter out of the mains socket.
● If the power fails during the charging, turn off the device
immediately and pull the USB adapter from the mains socket.
●
If smoke is produced, or there are any unusual sounds or smells,
switch off the Jumpstarter immediately and remove the mains
plug from the mains socket. In these cases, the Jumpstarter
should not be used until it has been inspected by the
manufacturer, or a similarly qualified person. Never inhale
smoke from a potential device fire. If you have inhaled smoke,
consult a doctor. The inhalation of smoke can be harmful.
●
For safety reasons, always disconnect the USB adapter in the
event of a thunderstorm.
USB cable & Jumper Cables
● Do not modify the cables.
● Check the cables periodically for damage. Never use a cable if
there are any signs of damage.
● Do not touch a jumper cable if it is damaged. A damaged cable
can cause a deadly electric shock.
● To prevent risks, damaged jumper cables may only be replaced
by the manufacturer, a professional workshop appointed by the
manufacturer, or a similarly qualified person.
● Never force a connector into a USB port. If the connector and
port don't come together easily, they probably don't match.
Check for obstructions and make sure the connector matches
the port and that you have correctly positioned the connector
with the port.
● Never unplug the USB cable from the adapter or the
Jumpstarter by pulling the cable. Always pull on the USB
connector.
●
Be careful not to trip over a cable.
● The cables must not be kinked, pinched, or twisted.
● Make sure that the cables are not squeezed, bent, damaged by
sharp edges, or put under mechanical stress.
● Never tie a knot in a cable and do not tie cables together.
● Avoid excessive thermal stress on the cables due to extreme
heat or cold.
To Next Page
Loading...