What causes solenoids and hand lamp to fail on JUKI Sewing Machine?
If the solenoids for thread trimming, reverse feed, wiper, etc., aren't working and the hand lamp doesn't light up on your JUKI sewing machine, the fuse for solenoid power protection may have blown. Check the fuse to see if it needs replacement.
What should I do if UP position move fails on my JUKI Sewing Machine?
If the UP position move fails to work and all the lamps on the panel light up on your JUKI sewing machine, the machine might be in the function setting mode. This can happen if the switch on the CTL p.c.b. is pressed by bound cords. Remove the front cover and arrange the cords following the regular binding procedure described in the Instruction Manual.
What does error E008 mean on JUKI DDL-8700?
The E008 error on your JUKI sewing machine indicates a machine head connector failure related to the resistance pack. This occurs when the machine head connector isn't properly read. To resolve this, check the machine head connector (CN32) for any loose connections or disconnections.
Step-by-step instructions for installing the sewing machine motor unit.
Procedure for attaching the control box to the sewing machine.
Guide for correctly installing and adjusting the tension of the drive belt.
How to adjust the pulley cover for optimal clearance and safety.
Installing and adjusting the protecting pin and belt slip-off prevention bracket.
Detailed instructions for connecting all necessary electrical cords and connectors.
Steps for attaching the connecting rod to the sewing machine's pedal mechanism.
Fundamental procedures for operating the SC-500 sewing machine.
Detailed overview of the buttons, displays, and functions of the control panel.
Instructions for configuring various operational functions of the SC-500.
A detailed list of all settable functions, their ranges, and default indications.
Detailed descriptions and usage of specific selectable machine functions.
Procedure to calibrate the neutral position of the pedal sensor for accurate operation.
Instructions for connecting and utilizing the AE device for bobbin thread monitoring.
Steps for correctly connecting the external pedal to the sewing machine.
Guide to setting up or turning off the automatic presser foot lifter function.
Instructions for connecting the material end sensor (ED) to the machine.
Procedure for restoring all machine settings to their factory default values.
Important safety precautions and steps for replacing internal fuses.
Guide on how to safely change the machine's operating voltage.
List of error codes, their causes, and recommended corrective actions.
General| Stitch Type | Lockstitch |
|---|---|
| Max Stitch Length | 5 mm |
| Needle Bar Stroke | 30.7 mm |
| Lift of the Presser Foot | By hand: 5.5 mm, By knee: 13 mm |
| Lubrication | Automatic |
| Max Sewing Speed | 5, 500 SPM |
| Type | Industrial Sewing Machine |
| Application | Medium weight materials |
| Hook | Rotating hook |
| Bobbin | Standard bobbin |
| Motor | Direct-drive servomotor |
| Dimensions | 420 x 180 x 360 mm |
To Next Page
