5y
Connecting
the
cords
Before starting to connect the cords, make sure that the power source is
cutout
Connect each
cord
with care
not
to
let
it
touch
the
motor
pulley, V-belt or any
other
moving parts.
Whileyou are connecting each plug, make sure that the plug is firmly secured in the receptacle by
trying to pull it lightly.
(1)
is
the
power
supply
cord.
(2) is the cord for the magnetic clutch brake which is pre-connected with 4-pole connector
(HITACHI) or 3-pole connector (MATSUSHITA).
(3) is the cord for controlling the knee lifter (2-pole connector). Only for AK-2.
(4) is the cord to the selector switch for controlling the count-back stitching (with 3-pole plug
for HITACHI, 6-pole plug for MATSUSHITA).
(5) is the cord to the wiper and the control lever for switch-back stitching (with 6-pole connec
tor). Pass the cord through the opposite side of the motor pulley via the hook beneath the
table
and
plug
in.
(6) is the cord for driving the thread trimmer solenoid and the automatic reversefeed solenoid,
(with
4-pole
connector).
(7) is
the
cord
to
drive the solenoid for
the
automatic
lifter (with 4-pole connector).
Only
for
AK-2.
(8) is the cord to the synchronizer, (with 12-pole connector
for
HITACHI and 8-pole connector
for
MATSUSHITA).
(9) is the pre-connected cord to the controller. (3-pole connector).
HITACHI
UUKI
- 4 -
To Next Page
Loading...
