High
speed
Low
speed
©
Stop
(needle
down)
Thread
trimming
o You can obtain the normal performance of thread trimming by treading on the pedal back
wards (heel-down) directly from the high or low speed position,
o You can
tread
back
the pedal
to
the
neutral
position
immediately
after
the
nachine
has
started
to perform the thread trimming action. The thread trimming action is automatically completed
and you do
not
need to keep the pedal at the thread trimming position any longer,
o When the machine stops, the needle will be held at the lower position.
o When you
want
to bring up the needle, tread on the pedal fully backwards (heel-down) once.
Then, the machine will perform a thread trimming action and will bring up the needle and hold
at
it's
highest position.
(Note)
In
some
cases,
the
machine
with
"MATSUSHITA"
motor,
does
not
start
to
run
immediately
after
a thread trimming action was made even though the pedal is trod forwards (toe-down). This is
simply because
the
machine is
locked
by the
safety
device
built
in tlic
motor
assembly. In such a
case,
tread
on the pedal
back
to
the
neutral
position
once
and tread on it again forwards to drive
the
machine.
In tlie
case
of
the
machine
with
"HITACHI"
motor,
such
safety
device is
automatically
released
after a thread trimming action has been completed.
- 7
To Next Page
Loading...
