– 2 –
(7) Amount of feed
･
The amount of feed is changed in increments of 0.2 mm by the stitch length adjusting dial.
(For the parallel parts of a buttonhole and satin stitches, the amount feed is changed in
increments of 0.1 mm.)
Default setting: 2.4 mm (for straight stitching)
(8) Pattern selection
･
10-pattern direct selection: MENU key + Numeric keys
･
Dot-matrix LCD
(9) Number of patterns that can be selected
･
Max. 70 patterns
(10) Number of patterns
･
HZL-F600 600
･
HZL-F400 450
･
HZL-F300 400
(11) Automatic threading device
･
The hook section makes a turn by lowering the threading lever, and automatically returns to its original
position after completion of threading.
(12) Automatic lock stitch
When the backtacking switch is turned ON:
･
Straight stitch: Three stitches are sewn in normal direction and three stitches are sewn in reverse
direction at the beginning and end (the reverse switch is turned ON) of sewing.
Amount of feed: Same with the preset amount of feed
･
Other patterns: Zero-feed is inserted and one each stitch is sewn in the normal and reverse directions
at the beginning and end (the reverse switch is turned ON) of sewing.
Amount of feed: Fixed at 0.6 mm
(13) Buttonholing
Auto-return type full automatic buttonholing
Buttonholing size detection
(14) Save and call patterns
Selected patterns and pattern settings can be stored in memory.
In addition, the pattern can be called up from memory for sewing.
Number of patterns that can be stored in memory: 10 (folders)
(15) Helpful messages
Presser foot lifting lever, buttonholing foot, display of pattern storage limitation, pattern clear prompt,
memory storage, acceptance of setting change, 2-needle setting, motor lock
To Next Page
Loading...
Need help?
General
