Need help?Do you have a question about the JUKI HZL-F series and is the answer not in the manual?
General| Needle Threader | Automatic |
|---|---|
| Lighting | LED |
| LCD Screen | Yes |
| Type | Computerized |
| Bobbin Type | Drop-in |
| Included Accessories | bobbins, needles |
| Automatic Thread Cutter | Yes |
Details about the power switch voltage specifications.
Specifies the power consumption in Watts.
Provides the main unit and case set dimensions and weight.
Details speed control for different stitch types and foot controller usage.
Explains how the machine stops after sewing or in case of fault.
States the maximum zigzag width available.
Explains how feed amount changes and its default setting.
Describes pattern selection methods and the LCD display.
Indicates the maximum number of patterns storable.
Lists the number of patterns for different HZL-F models.
Describes the function of the automatic threading device.
Explains the lock stitch function for different stitch types.
Mentions auto-return type full automatic buttonholing.
Describes pattern saving and recall capabilities.
Lists various helpful messages displayed by the machine.
Instructions for removing the top cover.
Steps to remove the face cover using setscrews.
Procedure to remove the throat plate by unscrewing it.
Detailed steps for removing the spool cover and related components.
Instructions for removing the bottom cover of the free arm.
Steps to remove the bed cover, including metal plate.
Procedure to remove the upper cover of the free arm.
Instructions for removing the face plate cover.
Steps for removing the front panel and its components.
Procedure to remove the rear panel with the presser foot lever raised.
Detailed procedures for adjusting needle bar height with specific values.
Steps to adjust the needle's entry point into the throat plate.
Procedure for adjusting the height of the feed dogs.
Instructions for adjusting the timing belt tension and position.
Procedure to adjust the timing between the needle and feed dog.
Steps to align needle and hook timing for correct stitch formation.
Adjusting the clearance between the needle and hook blade.
Balances clearances for right and left needle positions.
Procedure to set the position of the hook rotation stopper plate.
Instructions for adjusting the bobbin thread tension using a gauge.
Adjusts the thread tension release adjusting plate alignment.
Adjusts the pretension disk float for approximately 1 mm opening.
Adjusts clearance between tension disks to 1 mm.
Adjusts base tension opening amount to 1 mm.
Adjusts disk opening amounts for thread trimming.
Procedure to adjust needle thread tension using a tension gauge.
Adjusts the vertical position of the needle threading hook.
Adjusts the height of the auxiliary hook.
Adjusts the opening amount of the auxiliary hook.
Adjusts the presser foot lifting switch position.
Adjusts the presser bar height and alignment.
Adjusts the motor belt deflection.
Instructions for changing the thread trimming knife.
Procedure for adjusting the longitudinal feed for darning.
Explains how to access and navigate the service mode screen.
Lists and describes various service mode items and their functions.
To Next Page
