JUKI HZL-NX7 - Changing Throat Plate and Feed Dog

– 23 –
Base tension
Adjusting nut
Pre-tension
Tension disk
6-12 Adjusting the needle thread tension
○
Remove the thread tension cover.
Adjustmentprocedure
1. Turn the power ON. Select pattern No. 001 (straight stitch). Set the thread tension to the default value (0.0).
 2.Liftthepresserfoot.Preparepolyesterthread(SchappeSpun#60)andatensiongauge.Passthethread
throughthebasetension,pre-tensionandtensiondisk.
 4.Lowerthepresserfoot.Turntheadjustingnuttoadjustthetensionsothatthetensiongaugegivesaread-
ing of 0.49 to 0.59 N.