JUKI MO-50eN - Threading; Threading; Preparation; Upper looper (Blue)

A
B
A
B
24
Threading
Threading / Preparation
- Disconnect machine from
electricity supply.
- Support rod with thread guide
must be fully raised.
- Open the looper cover and the
colth plate cover.
- Turn the handwheel towards you
until needles are fully raised.
- Thread the machine in the correct
sequence.
- Place the spool on the spool
holder pin.
- Bring thread up from back to front
through guide (1).
- Pull the thread under the
guider (2) up to go around the
pre-tension (3).
- Thread guide (4,5,6).
- Thread looper eye (7).
Upper looper (Blue)
6
4
5
7
1
1
2
3
2134